| After-sales Service: | Yes |
|---|---|
| Type: | Silicone Sealant |
| Seal Tape Kind: | Anaerobic Adhesive |
| Seal Tape Usage: | Engineering |
| Material: | Silicone |
| State: | Dynamic Seal |
| Samples: |
|---|
| Customization: |
|---|
Suppliers with verified business licenses
Audited Supplier 
Manufacture Polyurethane Sealant Silicone Sealant Adhesive for automobile
| Product | Threadlokcer Glue |
| Product Introduction | a type of anaerobic adhesive, can inexpensively and permanently prevent threaded fastener failures. is a unique liquid resin that hardens (or cures) to a tough solid when exposed to metal ions in the absence of air. Thread locking agent is a one-component sealing adhesive made by using the principle of oxygen to free radical inhibition, which can be used for both bonding and sealing. When the glued surface is isolated from the air and catalyzed, it can be quickly polymerized and solidified at room temperature. |
| Feature | 1. The curing shrinkage rate is less, and the stress at the glue interface is small. 2. Curing at room temperature, and some glue joints can even be used at higher temperatures, which can save energy and facilitate assembly line operations. 3. The bonding strength of the glue varies widely, which is convenient for users to choose. 4. The thread agent is a one-component glue, which is stable in quality, easy to use, does not stain other containers, saves the amount of glue used, and has no waste. 5. Good permeability, vibration absorption and sealing. 6. Non-volatile, no pollution when used. 7. The glue of the outer glue seam where the glue joint is in contact with the air is not cured, and it is easy to remove. 8. The shelf life is more than one year, which is convenient for use in production. |
| usuage | 1. Before sizing, clean up the oil on the surface of the sizing part, etc., and dry the surface. 2. When the curing speed is very slow or the gap is large, an accelerator can be used on the surface to speed up the curing speed. 3. For a snug fit, simply apply a bead of glue around the chamfer of the shaft and bushing, turning as you assemble to ensure good application. 4. For a press fit, both surfaces to be bonded need to be fully coated and fitted with proper pressure. 5. For shrink fit, glue should be applied to the shaft, then the sleeve is heated to create enough clearance to fit freely. 6. Do not apply any applications to parts until they have reached sufficient operating strength. |
| Curing Time: | nitial 10min,full 3h |
| Packing | 10ml 50ml 250ml |
| Storage and shelf life | *Stored in its original unopened package in a dry and shady place below 27ºC |
| *12 months from manufacturing date | |
| Colors | Blue |
Suppliers with verified business licenses
Audited Supplier 
){kind=link}
){kind=link}